This circuit is similar to the
LED clock using 12 neon indicator lamps instead of LEDs. It operates from 2 high capacity
ni-cad cells (2.5 volts) which keep it going for a couple weeks. High voltage (70 volts)
for the neon lamps is obtained from a small switching power supply using a 74HC14 Schmitt
trigger squarewave oscillator, high voltage switching transistor, and 10 mH high Q
inductor. Most any small PNP transistors can be used that have a C/E voltage rating of 80
or more. The inverter stage (pins 5,6) is not needed and is just an extra stage. An
adjustable low frequency oscillator made from two of the inverter stages generates the
clock signal for the 74HCT393 binary counter. In this circuit, the timing capacitor should
be non-polarized since the capacitor will charge in both directions, so two 6.8 uF
tantalum caps were used back to back which yields about 3.3 uF. The 75K resistor in series
with pin 1 limits the current through the input protection diodes when the capacitor
voltage exceeds the supply voltage. This resistor may not be necessary with small
capacitors at low voltage but was added as a precaution. The binary counts are decoded
into 1 of 12 outputs by the 74HCT138 decoders and operates the same way as in the 28 LED
clock circuit. The sequence can be extended to 16 by omitting the reset circuit and tying
pins 2 and 13 of the counter to ground. |